Signaling (62) - Cisco BTS 10200 Troubleshooting Manual

Signaling Events and Alarms

SIGNALING (62)

For additional information, refer to the
Message—Signaling (62)" section on page
DESCRIPTION Received Integrated Services Digital Network RESTART Message (Received ISDN RESTART
Message)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS Termination Name–STRING [40]
Termination Index–FOUR_BYTES
Trunk Group ID–FOUR_BYTES
Trunk Group Index–FOUR_BYTES
Flag–FOUR_BYTES
PRIMARY Issued when an ISDN restart message was received from the specified gateway.
CAUSE
PRIMARY Monitor the event reports at the network level to verify that the specified gateway and terminations are
ACTION operating normally.
SIGNALING (63)
To troubleshoot and correct the cause of the alarm, refer to the
Faulty—Signaling (63)" section on page
DESCRIPTION Media Gateway/Termination Faulty
SEVERITY MAJOR
THRESHOLD 100
THROTTLE 0
DATAWORDS Fully Qualified Name–STRING [80]
Type of Gateway–STRING [32]
Reason for Failure–STRING [80]
PRIMARY Issued when a media gateway or termination has gone faulty due to the detection of an unknown
CAUSE endpoint, unknown package type, and unknown event, a hardware failure, or a general call agent error.
PRIMARY Verify the proper operation of the media gateway specified. Place the termination out-of-service and
ACTION then back into service from the call agent.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
10-34
"Received Integrated Services Digital Network RESTART
10-106.
"Media Gateway/Termination
10-137.
Chapter 10 Signaling Troubleshooting
OL-8723-19