Audit (3) - Cisco BTS 10200 Troubleshooting Manual

Chapter 2 Audit Troubleshooting

AUDIT (3)

To monitor and correct the cause of the event, refer to the
Code Audit Terminated Before Successful Completion—Audit (3)" section on page
DESCRIPTION Signaling System 7 Circuit Identification Code Audit Terminated Before Successful Completion (SS7
CIC Audit Terminated Before Successful Completion)
SEVERITY WARNING
THRESHOLD 100
THROTTLE 0
DATAWORDS Type of Audit–STRING [64]
PRIMARY A higher priority SS7 CIC audit interrupted and terminated a lower priority SS7 CIC audit.
CAUSE
PRIMARY Do not schedule an SS7 remote termination audit to occur while a periodic SS7 local termination audit
ACTION is executing.
AUDIT (4)
To monitor and correct the cause of the event, refer to the
Threshold—Audit (4)" section on page 2-18
DESCRIPTION Call Exceeds a Long-Duration Threshold
SEVERITY WARNING
THRESHOLD 100
THROTTLE 0
DATAWORDS Trunk group number–TWO_BYTES
Trunk member number–TWO_BYTES
Current long-duration threshold–TWO_BYTES
PRIMARY A call exceeded the current system long-duration threshold.
CAUSE
PRIMARY If there is a reason to believe the call is no longer valid, release the associated trunk facility.
ACTION
OL-8723-19
"Signaling System 7 Circuit Identification
"Call Exceeds a Long-Duration
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Audit Events and Alarms
2-18.
2-3