Signaling (133) - Cisco BTS 10200 Troubleshooting Manual

Signaling Events and Alarms

SIGNALING (133)

For additional information, refer to the
Message—Signaling (133)" section on page
DESCRIPTION Unable to Decode Generic Transport Descriptor Message (Unable to Decode GTD Message)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS Endpoint Name–STRING [40]
GTD Content Type–STRING [40]
PRIMARY Issued when the generic transport descriptor (GTD) parser failed to decode a GTD message received
CAUSE from the specified endpoint.
PRIMARY Verify that the version of the GTD protocol used by the device at the remote endpoint is consistent
ACTION with the version expected by the call agent.
SECONDARY Examine the associated signaling link to see if there is any interruption of the supplementary services
ACTION on the link.
SIGNALING (134)
For additional information, refer to the
(134)" section on page
DESCRIPTION Signaling System 7 Message Encoding Failure (SS7 Message Encoding Failure)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS CIC Number–TWO_BYTES
TGN-ID–FOUR_BYTES
DPC–STRING [20]
OPC–STRING [20]
PRIMARY An error in the ISDN user part (ISUP) stack or in a signaling adapter interface (SAI) message has
CAUSE occurred.
PRIMARY Capture the SS7 trace of circuit for examination by support personnel. (Contact Cisco TAC.)
ACTION
Refer to the
Note
detailed instructions on contacting Cisco TAC and opening a service request.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
10-70
10-118.
"Obtaining Documentation and Submitting a Service Request" section on page lvi
"Unable to Decode Generic Transport Descriptor
10-117.
"Signaling System 7 Message Encoding Failure—Signaling
Chapter 10 Signaling Troubleshooting
for
OL-8723-19