Signaling (139) - Cisco BTS 10200 Troubleshooting Manual

Signaling Events and Alarms

SIGNALING (139)

For additional information, refer to the
State—Signaling (139) (SS7)" section on page
DESCRIPTION Signaling System 7 Trunk was Found to be in Erroneous State (SS7 Trunk was Found to be in
Erroneous State)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS CIC–TWO_BYTES
TGN-ID–FOUR_BYTES
DPC–STRING [20]
OPC–STRING [20]
Near-End State–STRING [64]
Far-End State–STRING [64]
Resolution Action–STRING [64]
PRIMARY A discrepancy between the local and the remote trunk states has occurred.
CAUSE
PRIMARY Automatic corrective action is enforced when using American National Standards Institute (ANSI)
ACTION ISUP.
SIGNALING (140)
For additional information, refer to the
on page
DESCRIPTION Unanswered Information Message (Unanswered INF Message)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS CIC–TWO_BYTES
TGN-ID–FOUR_BYTES
DPC–STRING [20]
OPC–STRING [20]
PRIMARY The far-end switch is not responding to an information (INF) message with an information request
CAUSE (INR) message.
PRIMARY Verify that the far-end switch can correctly respond to an INF message.
ACTION
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
10-74
10-119.
"Signaling System 7 Trunk was Found to be in Erroneous
10-119.
"Unanswered Information Message—Signaling (140)" section
Chapter 10 Signaling Troubleshooting
OL-8723-19