Chapter 2. Message And Recovery Procedures - Cisco Intelligent Gigabit Ethernet Switch Module Manual

Chapter 2. Message and Recovery Procedures

This chapter describes the switch system messages in alphabetical order by facility.
Within each facility, the messages are listed by severity levels 0 to 7; 0 is the highest
severity level, and 7 is the lowest severity level. Each message is followed by an
explanation and a recommended action.
Notes:
1.
2.
This chapter contains these message categories:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
© Copyright IBM Corp. 2004
The messages listed in this chapter do not include the date/time stamp
designation that displays only if the software is configured for system log
messaging.
The Catalyst 2950 switch messages listed in this chapter also apply to the Cisco
Systems Intelligent Gigabit Ethernet Switch Module.
CIGESM Messages, on page 12
CMP Messages, on page 15
DOT1X Messages, on page 16
DTP Messages, on page 17
EC Messages, on page 18
ETHCNTR Messages, on page 21
HWMATM_MOD Messages, on page 22
PLATFORM_CAT2950 Messages, on page 22
PLATFORM_CATALYST2950 Messages, on page 26
PM Messages, on page 26
PORT SECURITY Messages, on page 31
SPAN Messages, on page 31
SPANTREE Messages, on page 32
SPANTREE_FAST Messages, on page 38
SPANTREE_VLAN_SWITCH Messages, on page 38
STORM_CONTROL Messages, on page 38
SW_VLAN Messages, on page 39
UDLD Messages, on page 43
UFAST_MCAST_SW Messages, on page 44
11