Success And Failure Responses - Cisco BTS 10200 Troubleshooting Manual

Chapter 14 General Troubleshooting

Success and Failure Responses

The following message is returned upon the success of a command:
Configuration Command Executed.
One of the following responses can be returned upon the failure of a command:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-8723-19
Administrative (ADM) found no failure.
ADM MGW(s) cannot be found.
ADM subscriber(s) cannot be found.
ADM trunk group(s) cannot be found.
ADM trunk(s) cannot be found.
ADM no termination(s) found in MGW.
ADM no trunk group(s) found in trunking gateway.
ADM no trunk(s) found in trunk group.
ADM fail while in termination table.
ADM fail while in trunk group table.
ADM fail while in trunk table.
ADM fail while looking to find trunk index.
ADM fail while getting MGW administration state.
ADM fail while getting trunk group administration state.
ADM fail while looking for MGW index.
ADM administration state invalid.
ADM failed to allocate inter-process communication (IPC) message(s).
ADM failed to dispatch IPC message(s).
ADM operational state invalid.
ADM MGW(s) state change and pending.
ADM subscriber(s) state change and pending.
ADM trunk group(s) state change and pending.
ADM trunk(s) state change and pending.
ADM found subscriber category invalid.
ADM found trunk group type invalid.
ADM found trunk group state invalid.
ADM found MGW admin state not ready.
ADM found trunk group admin state not ready.
ADM entity in desired state.
ADM not allow trunk to reset.
ADM not allow subscriber to reset.
ADM change to out-of-service state required.
ADM change to request graceful mode error.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Command Responses
14-7