Cisco BTS 10200 Troubleshooting Manual page 697

Chapter 15 Diagnostic Tests
The following is an example of the command line used to provision the collection of the call processing
measurement data:
change measurement-prov type=callp; enable=yes; time-interval=15;
The following is a list of the command line tokens associated with this command and the valid values
and purpose of each:
• Type—An ASCII character string from 3 to 8 inches long. The string must match one of the types
listed above. This is a mandatory token.
Enable—An ASCII character string of Yes or No. This string specifies whether or not to perform
•
collection on the specified measurement type. This is an optional token that is pre-provisioned with
a value of YES at the factory. Either this token and/or the time-interval token must be entered
Time-interval—A decimal value of 5, 15, 30, or 60. This value indicates the number of minutes each
•
reporting interval is to encompass for the given report type. The reporting interval is always
synchronized to zero minutes after the hour for consistency. This is an optional token that is
pre-provisioned with a value of 15 at the factory. Changing this value does not take effect until the
completion of the current collection interval based on the previous time-interval setting. Either this
token and/or the enable token must be entered.
The following are examples of the command line invocations to display the current settings for the data
described above:
show measurement-prov type=callp;
show measurement-prov type=anm;
show measurement-prov type=isdn;
show measurement-prov type=billing;
show measurement-prov type=em;
show measurement-prov type=snmp;
show measurement-prov type=mgcp;
show measurement-prov type=sim;
show measurement-prov type=pots-fs;
show measurement-prov type=ainsvc;
show measurement-prov type=tcap;
show measurement-prov type=m3ua;
show measurement-prov type=sua;
show measurement-prov type=sctp;
show measurement-prov type=sccp;
show measurement-prov type=isup;
show measurement-prov type=audit;
show measurement-prov type=sia;
show measurement-prov type=dqos;
OL-8723-19
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Enhanced Traffic Measurement
15-71