Table of Contents
Advertisement
Chapter 15
Diagnostic Tests
NCT Line Loopback Test over an ISDN Trunk with Service Affecting Turned Off and Parallel Test Connection Support Turned Off
This section provides example steps to use the feature for NTE NCT line test over an ISDN trunk with
service affecting turned off.
Perform the Following Command or Action:
Step 1
add destination dest-id=nlb-line-test;
call-type=test-call; call-subtype=nct-line-test;
Step 2
add dial plan id=<xxx>; digit-string=552;
dest-id=nlb-line-test; split-npa=none;
del-digits=0; min-digits=13; max-digits=13;
noa=national;
Note
Where <xxx> is an existing dial plan. The dial
plan id must match to the LB test prefix (for
example 552) in the digit string.
Step 3
add ca-config type=nlb-test-service-affecting=n;
datatype=boolean;value=n;
Then:
1.
2.
3.
4.
OL-8723-19
From the test equipment, dial the NTE NLB-LINE test call (552+xxx-xxx-xxxx). The BCM does
not notify the Feature Server of this call and the call is looped back.
Take the subscriber under test off-hook. There is a dial tone.
Call the subscriber under test from another subscriber. Call is set up, and the test call is released.
Hang up the test call and verify the Billing call type.
Purpose
Provision the Destination table.
Provision the Dial Plan table. The digit-string plus the
min-digits and max-digits total depends on the settings
configured (if any) in the
Table"
section.
Provision the Call Agent Configuration table with
service affecting off.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
ISDN Network Loopback Test
"Call Agent Configuration
15-63
Advertisement
Chapters
Table of Contents
Troubleshooting
