Termination Reason Responses - Cisco BTS 10200 Troubleshooting Manual

Chapter 14 General Troubleshooting

Termination Reason Responses

The following responses can be returned for the termination reason (term-reason) response for
subscriber termination and trunk termination commands:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-8723-19
All of wildcard too complicated
Channel-associated signaling (CAS) signaling protocol error
Codec negotiation failure
Endpoint does not have a digit map
Endpoint malfunctioning
Endpoint redirected to another Call Agent
Endpoint taken out of service
Error in RemoteConnectionDescriptor
Event/signal parameter error
Facility failure
Failure of a grouping of trunks
Incompatible protocol version
Insufficient bandwidth at this time
Insufficient bandwidth
Internal consistency in local connection options
Internal hardware failure.
Invalid call ID
Invalid conn identifier
Invalid or unsupported command parameter
Invalid or unsupported LocalConnectionOptions
Loss of lower connectivity
Loss of lower layer connectivity
Manual intervention
Missing remote connection descriptor
Missing remote connection descriptor
No fault reason available
No such event or signal
Packetization period not supported
Per endpoint connection limit exceeded
Quality of service (QoS) resource reservation was lost
Response too big
The media gateway is down
The media gateway is in a faulty state
The media gateway is transitioning to another state
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Command Responses
14-9