Stream Control Transmission Protocol Association Configuration Error—Signaling (112) - Cisco BTS 10200 Troubleshooting Manual

Chapter 10 Signaling Troubleshooting
Stream Control Transmission Protocol Association Configuration
Error—Signaling (112)
The Stream Control Transmission Protocol Association Configuration Error alarm (minor) indicates that
a SCTP association configuration error has occurred. The primary cause of the alarm is that the
destination IP address is invalid. To correct the primary cause of the alarm, input a new destination IP
address, see the log for additional details. The secondary cause of the alarm is that the local IP address
is invalid. To correct the secondary cause of the alarm, input new local IP address information. The
ternary cause of the alarm is that the IP Routing Table is not configured properly. To correct the ternary
cause of the alarm, have the system administrator configure IP routing table.
Message Transfer Part 3 User Adapter Troubleshooting Procedure
This alarm indicates that there is a provisioning error keeping the BTS 10200 from properly configuring
the SCTP association. Perform the following steps to resolve the problem:
To get more information about this alarm, look at the platform.log for error messages containing the
Step 1
string "Multipurpose Internet Mail (MIM) configuration (CFG)."
Perform Step 2 of the
Step 2
Internet Protocol Connections Down)—Signaling (111)" section on page 10-150
addresses and ports are properly configured on the BTS 10200.
Contact the Cisco TAC for assistance in resolving this issue.
Step 3
Signaling Connection Control Part User Adapter Troubleshooting Procedure
Refer to
configured on the BTS 10200.
OL-8723-19
"Stream Control Transmission Protocol Association Degraded (One of Two
Chapter 13, "Network Troubleshooting" to verify that the IP addresses and ports are properly
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Troubleshooting Signaling Alarms
to verify that your IP
10-151