Signaling (136) - Cisco BTS 10200 Troubleshooting Manual

Signaling Events and Alarms

SIGNALING (136)

For additional information, refer to the
(136)" section on page
DESCRIPTION Signaling System 7 Message Invalid Received (SS7 Message Invalid Received)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS CIC Number–TWO_BYTES
TGN-ID–FOUR_BYTES
DPC–STRING [20]
OPC–STRING [20]
PRIMARY An invalid message was received from the line in the ISUP stack.
CAUSE
PRIMARY Capture the SS7 trace of circuit for examination by support personnel. (Contact Cisco TAC.)
ACTION
SECONDARY An invalid message was received from the line in the ISUP stack.
CAUSE
SECONDARY Verify that the signal switching point (SSP) sending the message to the CA is correctly configured.
ACTION
Refer to the
Note
detailed instructions on contacting Cisco TAC and opening a service request.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
10-72
10-118.
"Obtaining Documentation and Submitting a Service Request" section on page lvi
"Signaling System 7 Message Invalid Received—Signaling
Chapter 10 Signaling Troubleshooting
for
OL-8723-19