Cisco BTS 10200 Troubleshooting Manual page 673

Chapter 15 Diagnostic Tests
Routing for Shared trunk-grp IP Testing Flow Chart Configuration Example
Use the following procedure as a routing for shared trunk-grp IP testing flow chart configuration
example.
Step 1 Add destination.
add destination dest-id=DEST_NLB_SUB; call-type=TEST-CALL; call-subtype=NLB-LINE-TEST;
route-type=SUB;
add destination dest-id=DEST_NCT_SUB; call-type=TEST-CALL; call-subtype=NCT-LINE-TEST;
route-type=SUB;
add destination dest-id=DEST_NLB_TRUNK; call-type=TEST-CALL; call-subtype=NLB-TRUNK-TEST;
route-type=ROUTE; route-guide-id=abc
add destination dest-id=DEST_NCT_TRUNK; call-type=TEST-CALL; call-subtype=NCT-TRUNK-TEST;
route-type=ROUTE; route-guide-id=abc
Add dial-plan-profile.
Step 2
add dial-plan-profile id=test; nanp-dial-plan=N
Add dial-plan.
Step 3
add dial-plan id=test; digit-string=151; dest-id=DEST_NLB_SUB; min-digits=13;
max-digits=13
add dial-plan id=test; digit-string=152; dest-id=DEST_NCB_SUB; min-digits=13;
max-digits=13
add dial-plan id=test; digit-string=153; dest-id=DEST_NLB_TRUNK; min-digits=13;
max-digits=13
add dial-plan id=test; digit-string=154; dest-id=DEST_NCT_TRUNK; min-digits=13;
max-digits=13
OL-8723-19
Network Loopback Test for Network-based Call Signaling/Media Gateway Control Protocol Endpoints
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
15-47