Siemens SINAMICS G150 Operating Instructions Manual page 302

Operation
6.6 Control via the operator panel
Normalization to motor current
In this menu, the reference variable for the bar-type display of parameter r0027 (absolute
current actual value smoothed) can be changed over in the operating screen forms.
Normalization to motor current (factory setting: NO)
● Yes:The bar-type display of parameter r0027 in the operating screen form is displayed
● No:The bar-type display of parameter r0027in the operating screen form is displayed
Reset AOP settings
When you choose this menu option, the AOP factory settings for the following are restored:
● Language
● Display (brightness, contrast)
● Operation screen
● Control settings
NOTICE
When you reset parameters, all settings that are different to the factory settings are reset
immediately. This may cause the cabinet unit to switch to a different, unwanted operational
status.
For this reason, you should always take great care when resetting parameters.
Curve recorder settings
In this menu, you can select the parameter whose signal is to be displayed in the form of a
trend curve in the curve recorder.
In addition, the setting of the interpolation can be selected to better display quantities that
suddenly change (as a step function).
Interpolation (factory setting: NO)
● NO:Only the measured values are displayed as points, without a connecting line between
● 1: The measured values are connected by a vertical line.
● 2: The measured values are connected by a line offset at the center.
300
based on parameter p0305 (rated motor current).
based on parameter p2002 (reference current).
points.
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A