Additional Settings Required For Units That Are Connected In Parallel - Siemens SINAMICS G150 Operating Instructions Manual

Converter cabinet units 75 kw to 1500 kw

Hide thumbs Also See for SINAMICS G150:

Table of Contents

Commissioning

5.5 First commissioning with the AOP30

Make sure that the necessary enable signals have been assigned; otherwise motor

identification cannot be carried out.

If a fault is present when selecting the stationary or rotary measurement, motor identification

cannot be carried out.

To rectify the fault, you must choose "No identification" to close the screen, then eliminate

After this, motor identification can be selected again via <MENU> -

<Commissioning/service> - <Drive commissioning> - <Motor identification>.

Additional settings required for units that are connected in parallel

Additional settings must be made for units that are connected in parallel before selecting the

motor and entering the motor data via the operator panel:

● For 3 AC 380 to 480 V:

● For 3 AC 500 to 600 V:

● For 3 AC 660 to 690 V:

6SL3710-2GE41-1AAx, 6SL3710-2GE41-4AAx, 6SL3710-2GE41-6AAx

6SL3710-2GF38-6AAx, 6SL3710-2GF41-1AAx, 6SL3710-2GF41-4AAx

6SL3710-2GH41-1AAx, 6SL3710-2GH41-4AAx, 6SL3710-2GH41-5AAx

Converter cabinet units

Operating Instructions, 03/2012, A5E03263466A