General Information About Command And Setpoint Sources - Siemens SINAMICS G150 Operating Instructions Manual

Operation

6.2 General information about command and setpoint sources

6.2 General information about command and setpoint sources
Description
Four default settings are available for selecting the command sources and four for selecting
the setpoint sources for the SINAMICS G150 cabinet unit. The choice "no selection" is also
available; if selected, no default settings are applied for the command and setpoint sources.
Command sources
● PROFIdrive
● TM31 terminals
● NAMUR
● PROFIdrive NAMUR
Setpoint sources
● PROFIdrive
● Analog inputs
● Motorized potentiometer
● Fixed setpoints
The various assignments are explained in the following sections.
Note
Make sure that the default settings you choose during commissioning are compatible with
the cabinet configuration (see "Commissioning")
Emergency STOP signals (L57, L59, and L60) and motor protection signals (L83 and L84)
are always active (regardless of the command source).
Function diagrams
At certain points in this chapter, reference is made to function diagrams. These can be found
on the customer DVD in the "SINAMICS G130/G150 List Manual", which provides
experienced users with detailed descriptions of all the functions.
258
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A