Siemens SINAMICS G150 Operating Instructions Manual page 328

Operation
6.7 Communication according to PROFIdrive
Error
value
0x06 Illegal set operation (only reset
allowed)
0x07 Description element cannot be
changed
0x09 No description data available
0x0B No parameter change rights.
0x0F No text array exists
0x11 Request cannot be executed due to
operating status.
0x14 Illegal value.
0x15 Response too long.
0x16 Illegal parameter address.
0x17 Illegal format.
0x18 Number of values inconsistent.
0x19 Drive object does not exist.
0x65 Parameter presently deactivated.
0x6B Parameter %s [%s]: no write access
for the enabled controller.
0x6C Parameter %s [%s]: unit unknown.
0x6D Parameter %s [%s]: write access only
in the commissioning state, encoder
(p0010 = 4).
0x6E Parameter %s [%s]: write access only
in the commissioning state, motor
(p0010 = 3).
0x6F Parameter %s [%s]: write access only
in the commissioning state, power
module (p0010 = 2).
0x70 Parameter %s [%s]: write access only
in quick commissioning (p0010 = 1).
0x71 Parameter %s [%s]: write access only
in the ready state (p0010 = 0).
326
Meaning Comment
Modification access with a value not equal to 0 in a case
where this is not allowed.
Modification access to a description element that cannot
be changed.
Access to a description that does not exist (the parameter
value exists).
Modification access with no parameter change rights.
Access to a text array that does not exist (the parameter
value exists).
Access is temporarily not possible for unspecified reasons. –
Modification access with a value that is within the limits but
is illegal for other permanent reasons (parameter with
defined individual values).
The length of the present response exceeds the maximum
transfer length.
Illegal or unsupported value for attribute, number of
elements, parameter number, subindex or a combination
of these.
Write request: illegal or unsupported parameter data
format.
Write request: a mismatch exists between the number of
values in the parameter data and the number of elements
in the parameter address.
You have attempted to access a drive object that does not
exist.
You have tried to access a parameter that, although
available, does not currently perform a function
(e.g., n control set and access to a U/f control parameter).
–
–
–
–
–
–
–
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A
Additional
info
Subindex
Subindex
–
–
–
Subindex
–
–
–
–
–
–
–
–
–
–
–
–
–