Siemens SINAMICS G150 Operating Instructions Manual page 273

Interconnecting signals using BICO technology
To interconnect two signals, a BICO input parameter (signal sink) must be assigned to the
desired BICO output parameter (signal source).
The following information is required in order to connect a binector/connector input to a
binector/connector output:
• Binectors:
• Connectors with no index: Parameter number and drive object ID
• Connectors with index:
Figure 6-5
Note
A connector input (CI) cannot be interconnected with any connector output (CO, signal
source). The same applies to the binector input (BI) and binector output (BO).
"Data type" in the parameter list provides information about the data type of the parameter
and the data type of the BICO parameter for each CI und BI parameter.
For CO and BO parameters, only the data type of the BICO parameter is given.
Notation:
• Data type BICO input: Data type parameter / Data type BICO parameter
• Data type BICO output: Data type BICO parameter
The possible interconnections between BICO input (signal sink) and BICO output (signal
source) are described in the List Manual in the table "Possible combinations for BICO
interconnections" in the section "Explanations on the parameter list".
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A
Interconnecting signals using BICO technology
Example: Unsigned32 / Integer16
Example: FloatingPoint32
6.3 Basic information about the drive system
Parameter number, bit number, and drive object ID
Parameter number, index, and drive object ID
Operation
271