Commissioning
5.3 Procedure for commissioning via STARTER
Note
With SINAMICS G150, only CDS0 is normally used as a default setting for the command and
setpoint sources.
Make sure that the selected default setting is compatible with the actual system
configuration.
Note
The choice "no selection" is also available as default setting for the command and setpoint
sources; if selected, no default settings are applied for the command and setpoint sources.
⇒ Check your default settings carefully and then click Continue >
Defining the technological application/motor identification
Figure 5-26
226
Defining the technological application/motor identification
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A