Display Indications In The Monitoring Mode Settings - WEG CFW-11 Programming Manual

5.6 DiSPLay iNDicatioNS iN tHe MoNitoRiNG MoDe SettiNGS

Every time the inverter is powered the display goes to the Monitoring Mode. In order to make it easier the
reading of the motor main parameters, the keypad (HMI) display can be configured to show them in 3
different modes.
Content of the 3 parameters in numerical form:
Selection of the parameters via P0205, P0206 and P0207. That mode can be seen in the figure 5.3.
Motor speed direction
indication.
Inverter status:
- Run
- Ready
- Configuration
- Self tuning
- Last fault: FXXX
- Last alarm: AXXX
- etc.
Left "soft key" function.
Content of the 3 parameters in form of a bar graph:
Selection of the parameters via P0205, P0206 and/or P0207. The values are showed in percentage by means
of horizontal bars. This mode is illustrated in the figure 5.4.
Run
rpm
A
Hz
In order to configure the bar graph monitoring mode, access the parameters P0205, P0206 and/or P0207
and select the options ended with the symbol "–" (values in the range from 11 to 20). Thus, the respective
variable is configured to be shown as a bar graph.
The figure 5.5, presented next, illustrates the procedure for the modification of the display of one variable
to the graph mode.
Loc./Rem. indication
- LOC: Local situation;
- REM: Remote situation.
Run 1800rpm
LOC
1800 rpm
1.0 A
60.0 Hz
12:35 Menu
Right "soft key" function.
Indication of the time.
Adjusted in:
P0197, P0198 and P0199.
Figure 5.3 - Monitoring Mode screen at the factory setting
Monitoring parameters:
- Motor speed in rpm;
- Motor current in Amps;
1800rpm
LOC
- Output frequency in Hz (default).
100%
10%
P0205, P0206 and P0207: selection of the parameters
100%
to be shown in the Monitoring Mode.
12:35 Menu
P0208 to P0212: Engineering unit for the speed
indication.
Figure 5.4 - Monitoring Mode screen with bar graphs
Programming Basic Instructions
Motor speed indication
in rpm.
Monitoring parameters:
- Motor speed in rpm;
- Motor current in Amps;
- Output frequency in Hz (default).
P0205, P0206 and P0207: selection of the
parameters to be shown in the Monitoring Mode.
P0208 to P0212: Engineering unit for the speed
indication.
5
5-9