Setting Date And Time - WEG CFW-11 User Manual

First Time Power-Up and Start-Up

5.3 SETTING DATE AND TIME

5
5-8 | CFW-11
Step Action/Result
1 Monitoring mode
- Press "Menu"
(right soft key)
2 - Group "00
ALL PARAMETERS" is already
selected
3 - Group "01
PARAMETER GROUPS" is
selected
- Press "Select"
4 - A new list of groups is
displayed and group "20
Ramps" is selected
- Press until you reach
group "30 HMI"
5 - Group "30 HMI" is selected
- Press "Select"
6 - Parameter "Day P0194" is
already selected
- If needed, set P0194
according to the actual day.
To do so, press "Select" and
then, or
change P0194 value
- Follow the same steps to set
parameters "Month P0195" to
"Seconds P0199"
7 - Once the setting of P0199 is
over, the Real Time Clock is
now updated
- Press "Return"
(left soft key)
8 - Press "Return"
9 - Press "Return"
10 - The display is back to the
Monitoring mode
Figure 5.4 - Setting date and time
Display Indication
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
16:10 Menu
Ready LOC 0rpm
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 16:10 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 16:10 Select
Ready 0rpm
LOC
20 Ramps
21 Speed References
22 Speed Limits
23 V/F Control
Return 16:10 Select
Ready 0rpm
LOC
27 V/F DC Volt. Limit.
28 Dynamic Braking
29 Vector Control
30 HMI
Return 16:10 Select
Ready LOC 0rpm
Day
P0194: 06
Month
P0195: 10
Return 16:10 Select
to
Ready 0rpm
LOC
Minutes
P0198: 11
Seconds
P0199: 34
Return 18:11 Select
Ready LOC 0rpm
27 V/F DC Volt. Limit.
28 Dynamic Braking
29 Vector Control
30 HMI
Return 18:11 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 18:11 Select
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
18:11 Menu