Stb; Trg - Agilent Technologies 4288A Programming Manual

Command Reference

*STB?

*STB?
Syntax
*STB?
Description
Reads out the value of the Status Byte Register. (Query only)
Query response
{numeric}<newline><^END>
Equivalent key
No equivalent key is available on the front panel.
sequence

*TRG

Syntax *TRG
Description
If the trigger source is set to GPIB (set to BUS with the (:TRIG:SOUR command),
triggers the 4288A as it waits for a trigger and reads out the measured data after the
measurement is completed.
The transfer format of data read out with this command conforms to the setup of the
:FORM command.
NOTE
Although this command does not have "?", query response is given.
Query response It is the same as that of the :FETC? command. For details, refer to the description of
:FETC?.
Related commands :FETC? on page 181
:TRIG:SOUR on page 196
:FORM on page 182
Equivalent key
No equivalent key is available on the front panel.
sequence
128 Chapter 10