Agilent Technologies 4288A Programming Manual page 229

Differences in usage of GPIB commands
Reference value
GPIB command correspondence
Table B-14 Correspondence of setup commands related to screen display
Display format
Displayed item on
the monitor display
Number of display
digits for the
measurement
Display mode
Appendix B
Functional Comparison and GPIB Command Correspondence
You cannot set an independent reference
value for deviation display. The reference
for deviation
value (nominal value) in the comparator
display
tolerance mode is applied.
Setup
Measured value display format
(MEAS PAGE)
Limit table display format
(LIMIT PAGE)
Classification display format
(SORT PAGE)
Compensation value display
format
(STATUS PAGE)
Monitor display OFF
Data for OPEN compensation VMON1
Data for SHORT compensation VMON2
Data for LOAD compensation VMON3
Reference value for LOAD
compensation (definition value
of the standard for LOAD
compensation)
Data for offset compensation
Nominal value (reference
value) for the tolerance mode of
the comparator function
4
5
6
result
MEAS display mode
(normal display)
TOL display mode (percentage
display of deviation
*1.For the 4278A, use the NOM= command to set the reference value. For the 4288A, use
the :DATA {REF1|REF2} command to set the reference value.
Information for Replacing 4278A with 4288A
4278A
You can set an independent reference
value for deviation display.
GPIB command
4278A
DPAG1 There is no corresponding command.
Refer to Table B-12 and use the following
command to set up the displayed page of
DPAG2
the instrument setup display area so that
the closest state is realized.
DPAG3
:DISP:TEXT2:PAGE
DPAG4
VMON0
VMON4
VMON5
VMON6
DDIG4 :DISP:TEXT1:DIG 4
DDIG5 :DISP:TEXT1:DIG 5
DDIG6 :DISP:TEXT1:DIG 6
DVAL1 :CALC1:MATH:STAT OFF
DVAL2 :CALC1:MATH:STAT ON
*1 :CALC1:MATH:EXPR:NAME PCNT
)
4288A
4288A
227