Agilent Technologies 4288A Programming Manual page 161

• When specifying STANdard3 as parameter 1:
Description
Range
Initial value
Unit
In any case, if the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if the upper
limit of the range is exceeded) is set.
MAX or MIN can be used to specify parameter 2 and parameter 3.
Query response
{numeric 1},{numeric 2}<newline><^END>
Related commands :CORR:OPEN on page 165
:CORR:SHOR on page 165
:CORR:LOAD on page 160
:CORR:MULT on page 161
:CORR:MULT:CHAN on page 161
:CORR:CKIT:STAN1:FORM on page 154
:CORR:CKIT:STAN2:FORM on page 154
:CORR:CKIT:STAN3:FORM on page 156
:FORM on page 182
Equivalent key
[Open]
sequence
[Short]
[Load]
You can only check the setup values. You cannot set them.
Chapter 10
Parameter 2: <numeric 1>
Value of the primary parameter
-999.999 to 999.999
100E-9
F (farad)
*1.Use the :CORR:CKIT:STAN3:FORM command to specify the type of parameter.
( - ) -
[Blue] [4] MeasVal
( [Blue] - [5] ) - MeasVal
( [Blue] - [6] ) - CorVal - MeasVal
Command Reference
:CORR:DATA
Parameter 3: <numeric 2>
*1 Value of the secondary
.
*1
parameter .
-99.9999E9 to 99.9999E9
0
Depends on the type of parameter.
159