Sample Program - Agilent Technologies 4288A Programming Manual

Sample Program

Example 3-1 shows a sample program to set up the measurement conditions and display.
This program is stored on the sample program disk under the filename "setup.bas."
This program performs reset, sets up the 4288A as shown in the following table, and saves
the setups into the built-in nonvolatile memory (save location number: 9).
Item
Measurement Primary parameter
parameter
Secondary parameter
Measurement signal Frequency
Level
Measurement range
Measurement time
Averaging count
Cable length
Trigger delay time
Display ON/OFF
Number of display digits for the measurement
result
Fixed point display for the measurement result
Deviation Mode
measurement mode
Reference value
(Primary parameter)
Deviation Mode
measurement mode
Reference value
(Secondary
parameter)
Page number of the instrument setup display area
Measurement signal Current
level monitor
Voltage
Beep mode
Chapter 3
Setting Up Measurement Conditions and Display
Setup
Cp
D
1 kHz
500 mV
Auto range mode
Long mode
4
0 m
1 ms
ON
5
OFF
Percentage display
10 nF
OFF
0
4 (the page that displays the measurement signal level
monitor result)
OFF
ON
FAIL
Sample Program
31