Agilent Technologies 4288A Programming Manual page 225

Table B-11 Correspondence of comparator function commands
Setting limit range in
the tolerance mode
AUX BIN function
BIN count function
Appendix B
Functional Comparison and GPIB Command Correspondence
Setup
BIN4
BIN5
BIN6
BIN7
BIN8
BIN9
Setting limit range in the sequential mode
Secondary parameter limit range
Clearing the limit range
OFF
ON
OFF
Limit 1%, ON
Limit 2%, ON
Low C reject
Limit 3%, ON
*2
function
Limit 4%, ON
Limit 5%, ON
Limit 6%, ON
OFF
ON
Resetting the count value RCNT
Reading out the count
value
Reading out the count
value for each channel
*1.For the 4288A, this setup is commonly applied to the measurement parameters. There-
fore, the command to set up each measurement parameter is given here.
*2.The limit is specified as a percentage of the measurement range. Thus, for the same
limit (%) value, the 4278A and the 4288A may show different boundary values where
Low C is actually detected if the measurement ranges are not identical.
Information for Replacing 4278A with 4288A
GPIB command
4278A 4288A
:CALC:COMP:PRIM:BIN4
BIN4=
:CALC:COMP:PRIM:BIN4:STAT ON
:CALC:COMP:PRIM:BIN5
BIN5=
:CALC:COMP:PRIM:BIN5:STAT ON
:CALC:COMP:PRIM:BIN6
BIN6=
:CALC:COMP:PRIM:BIN6:STAT ON
:CALC:COMP:PRIM:BIN7
BIN7=
:CALC:COMP:PRIM:BIN7:STAT ON
:CALC:COMP:PRIM:BIN8
BIN8=
:CALC:COMP:PRIM:BIN8:STAT ON
:CALC:COMP:PRIM:BIN9
BIN9=
:CALC:COMP:PRIM:BIN9:STAT ON
No equivalent command is available.
However, the same functionality can be
obtained by setting the limit mode to the
BLIM=
absolute mode and then setting up each BIN
with the same command as in the tolerance
mode.
:CALC:COMP:SEC:LIM
SLIM=
:CALC:COMP:SEC:STAT ON
CLIM :CALC:COMP:CLE
AUX0 :CALC:COMP:AUXB OFF
AUX1 :CALC:COMP:AUXB ON
CREJ0 :CREJ OFF
CREJ1 :CREJ:LIM 1
CREJ2 :CREJ:LIM 2
CREJ3 :CREJ:LIM 3
CREJ4 :CREJ:LIM 4
CREJ5 :CREJ:LIM 5
CREJ6 :CREJ:LIM 6
CNT0 :CALC:COMP:COUN OFF
CNT1 :CALC:COMP:COUN ON
:CALC:COMP:COUN:CLE
:CALC:COMP:COUN:DATA?
COUN?
:CALC:COMP:COUN:OVLD?
:CALC:COMP:COUN:MULT:DATA?
CCOU?
:CALC:COMP:COUN:MULT:OVLD?
:CREJ ON
:CREJ ON
:CREJ ON
:CREJ ON
:CREJ ON
:CREJ ON
223