Manual Changes - Agilent Technologies 4288A Programming Manual

Manual Changes

Manual Changes
Manual Changes
To adapt this manual to your Agilent 4288A, refer to Table A-1 and Table A-2.
Table A-1 Manual Changes by Serial Number
Table A-2 Manual Changes by Firmware Version
Agilent Technologies uses a two-part, ten-character serial number that is stamped on the
serial number plate (Figure A-1). The first five characters are the serial prefix and the last
five digits are the suffix.
Execute the *IDN? command on page 125 to check the firmware version.
Figure A-1 Serial Number Plate (Example)
208
Serial Prefix or Number
Version
1.00
1.10
Make Manual Changes
Make Manual Changes
"Change 1" on page 209, "Change 2" on page 209
"Change 2" on page 209
Appendix A