Agilent Technologies 4288A Programming Manual page 241

Table B-25 At-a-glance list of GPIB command correspondence between 4278A and 4288A
(alphabetical order)
4278A
DSTD= Sets the D value of the standard for the standard (LOAD) compensation.
DTIM= Sets the delay time (trigger delay time).
DVAL{1|2}
Sets the display mode.
ERR?
Reads out the error message number.
FREQ{1|2}
Sets the measurement frequency.
GSTD=
Sets the G value of the standard for the standard (LOAD) compensation.
HIAC{0|1} Turns ON/OFF the HI-ACC mode.
ITIM{1-3} Sets the integration time (measurement time).
LMOD{1-3} Sets the limit mode (limit range specification method).
LOAD
Loads (recalls) the measurement condition.
LPAR{1-6} Sets the parameter to be sorted by the comparator.
MCOM{0|1} Turns ON/OFF multi-compensation.
MPAR{1-6}
Sets the measurement parameter.
NOM= Sets the nominal value (reference value) in the tolerance mode.
OFFA= Sets the offset compensation value for the primary parameter.
OFFB=
Sets the offset compensation value for the secondary parameter.
OPEN{0|1} Turns ON/OFF the OPEN compensation.
OPM?
Reads out the measured OPEN compensation value (data for OPEN
compensation).
OSC= Sets the OSC level (measurement signal level).
RA{0-7} Sets the measurement range when the measurement frequency is 1 kHz.
RB{0-11}
Sets the measurement range when the measurement frequency is 1 MHz.
RC= Sets the measurement range value for the HI-ACC mode.
RCNT Resets the BIN count value.
REVP{0|1} Turns ON/OFF the reverse parameter function.
Appendix B
At-a-Glance List of GPIB Command Correspondence
Function overview
[ E ]
[ F ]
[ G ]
[ H ]
[ I ]
[ L ]
[ M ]
[ N ]
[ O ]
[ R ]
[ S ]
Information for Replacing 4278A with 4288A
4288A
:CORR:CKIT:STAN3 on page 155
:TRIG:DEL on page 195
:CALC1:MATH:EXPR:NAME on page 148
:SYST:ERR? on page 192
:SOUR:FREQ on page 187
:CORR:CKIT:STAN3 on page 155
N/A
:APER on page 130
:CALC:COMP:MODE on page 141
*RCL on page 126
N/A (Dependent on the measurement
parameter and cannot be set up separately.)
:CORR:MULT on page 161
:CALC1:FORM on page 147,
:CALC2:FORM on page 150
:CALC:COMP:PRIM:NOM on page 144
:CORR:OFFS:DATA on page 164
:CORR:OPEN on page 165
:CORR:DATA on page 158
:SOUR:VOLT on page 188
:RANG on page 184
:RANG:AUTO on page 185
N/A
:CALC:COMP:COUN:CLE on page 137
N/A
239