Sorting Based on Measured Result (Comparator Function)
Setting Up Comparator Function
Setting Up Comparator Function
Turning ON/OFF comparator function
To enable/disable the comparator function, use the following command.
•
Setting up limit range
Clearing (resetting) limit range
You can clear the ON/OFF state and the lower and upper limit values of all limit ranges
(BIN1 to BIN9 and the secondary parameter limit range) and the ON/OFF state of AUX
BIN to recover the factory-shipped default values (refer to Table D-1, "Initial settings,
settings that can be saved/recalled, settings that can be backed up," on page 259).
To clear the limit ranges, use the following command.
•
Selecting limit range designation method
You can select the designation method of the primary parameter limit ranges (BIN1 to
BIN9) from the following three modes:
NOTE
Only the absolute mode can be used as the designation method of the secondary parameter
limit range.
To select the designation method, use the following command.
•
To set up the reference value for the absolute tolerance mode or percent tolerance mode,
use the following command.
•
82
:CALC:COMP on page 134
:CALC:COMP:CLE on page 136
Mode
Absolute mode
Absolute tolerance mode
Percent tolerance mode
*1.Boundary value - reference value
*2.((Boundary value - reference value)/reference value)× 100
:CALC:COMP:MODE on page 141
:CALC:COMP:PRIM:NOM on page 144
Description
Designation using the absolute value
Designation using the
relative value (deviation
from the reference value)
Designation using the absolute
*1
value
Designation using the percentage of
*2
the reference value
Chapter 7