Table of Contents
Advertisement
Preparation for Accurate Measurement (Executing Compensation)
Using the Multi-compensation Function
Using the Multi-compensation Function
Turning ON/OFF the multi-compensation function
To turn ON/OFF the multi-compensation function, use the following command.
:CORR:MULT on page 161
•
Selecting a channel
To select a channel for the multi compensation function, use the following command.
•
:CORR:MULT:CHAN on page 161
Measuring compensation data
Selecting the definition method of the LOAD compensation standard
To select whether to define the LOAD compensation standard value (LOAD compensation
reference value) for each channel individually or for all channels commonly, use the
following command.
•
:CORR:MULT:CKIT:STAN3 on page 162
Measuring compensation data
The method to measure the OPEN/SHORT/LOAD compensation data for
multi-compensation is the same as that for basic compensation data except that you need to
select the proper channel before measurement. For more details, refer to "Measuring
compensation data" on page 36.
Reading/writing compensation data
The method used to read/write the OPEN/SHORT/LOAD compensation data for
multi-compensation is the same as that for basic compensation data except that you need to
select the proper channel before measurement. For more details, refer to "Reading/writing
compensation data (saving/recalling compensation conditions)" on page 37.
46
Chapter 4
- Quick Links:
- Looking up Gpib Commands
Hide quick links:
Advertisement
Table of Contents
