Disp; Disp:text1:Dig - Agilent Technologies 4288A Programming Manual

Command Reference

:DISP

:DISP
Syntax
:DISPlay[:WINDow][:STATe] {ON|OFF|1|0}
:DISPlay[:WINDow][:STATe]?
Description Enables/disables the display of the measurement result.
If you disables the display, "DISP OFF" is always displayed on the screen.
Parameters
Query response {1|0}<newline><^END>
Equivalent key
[Disp Mode]
sequence

:DISP:TEXT1:DIG

Syntax :DISPlay[:WINDow]:TEXT1[:DATA]:DIGit <numeric>
:DISPlay[:WINDow]:TEXT1[:DATA]:DIGit?
Description
Specifies the number of displayed digits for both the primary and secondary parameters.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response
{numeric}<newline><^END>
Equivalent key
[Disp Mode]
sequence
176
ON or 1 (initial value)
OFF or 0
( [Blue] - [Freq]
Description Number of displayed digits for the primary/secondary parameter
Range 4 to 6
Initial value 6
Unit Digit
Resolution 1
( [Blue] - [Freq]
Description
Enables the display.
Disables the display.
) - On/Off
<numeric>
) - Digit
Chapter 10