Corr:offs:data - Agilent Technologies 4288A Programming Manual

Command Reference

:CORR:OFFS:DATA

:CORR:OFFS:DATA
Syntax
[:SENSe]:CORRection:OFFSet:DATA <numeric 1>,<numeric 2>
[:SENSe]:CORRection:OFFSet:DATA?
Description Sets the compensation values for the primary parameter and secondary parameter used in
the offset compensation function.
These compensation data are measured for the measurement frequency used in executing
the command (set with the :SOUR:FREQ command).
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set. Note that the unit of the parameter changes depending on the
limit range designation method.
MAX or MIN can be used to specify the parameters.
Query response
{numeric 1},{numeric 2}<newline><^END>
Related commands :CORR:OFFS on page 163
Equivalent key
[Offset]
sequence
164
Description The offset compensation value for
the primary parameter.
Range -999.999 to 999.999
Initial value 0
Unit F (farad)
( - ) -
[Blue] [3] OfsEnt
<numeric 1> <numeric 2>
The offset compensation value for
the secondary parameter.
-99.9999E9 to 99.9999E9
0
Depends on the setup of the
secondary parameter.
Chapter 10