Rejecting Excessively Low Measured Results (Low C Reject Function); Turning On/Off Low C Reject Function; Setting Limit (Range Boundary Values) Of Low C Reject Function - Agilent Technologies 4288A Programming Manual

Rejecting Excessively Low Measured Results (Low C reject
function)

Turning ON/OFF Low C reject function

To turn ON/OFF the Low C reject function, use the following command.
:CREJ on page 166
•
You can detect an excessively low (equal to or less than the preset boundary value)
measured result of the primary parameter value (Cp or Cs) as Low C (abnormal
measurement status) by turning ON the Low C reject function.
NOTE When the comparator function is ON, the sorting judgment is performed normally even if
Low C is detected. However, the sorting judgment result displayed on the screen is LOWC
and, on the handler interface, the /LOW_C_REJECT signal becomes active (LOW) in
addition to the sorting judgment signal.

Setting limit (range boundary values) of Low C reject function

To set the limit (boundary values of the range in which Low C is detected) of the Low C
reject function, use the following command.
:CREJ:LIM on page 167
•
Chapter 7
Sorting Based on Measured Result (Comparator Function)

Rejecting Excessively Low Measured Results (Low C reject function)

85