Agilent Technologies 4288A Programming Manual page 242

Information for Replacing 4278A with 4288A
At-a-Glance List of GPIB Command Correspondence
Table B-25 At-a-glance list of GPIB command correspondence between 4278A and 4288A
(alphabetical order)
4278A
SHM? Reads out the measured SHORT compensation value (data for SHORT
compensation).
SHOR{0|1} Turns ON/OFF the SHORT compensation.
SLIM= Sets the limit range of the secondary parameter.
SPAR{1|2} Sets the definition parameter of the standard for standard (LOAD)
compensation.
STD{0|1} Turns ON/OFF standard (LOAD) compensation.
STM?
Reads out the measured standard compensation value (data for LOAD
compensation).
STOR
Stores (saves) the measurement condition.
STR?
Reads out the standard compensation reference value (setup value of the
standard for LOAD compensation).
TRIG{1-3} Sets the trigger mode.
VMON{0-6}
Sets the items to be displayed.
XOP Makes a measurement to obtain the measured OPEN compensation value
(data for OPEN compensation).
XSH Makes a measurement to obtain the measured SHORT compensation value
(data for SHORT compensation).
XSTD Makes a measurement to obtain the measured standard compensation value
(data for LOAD compensation).
XTMP
Executes the temperature compensation.
*CLS
Clears the status byte register.
*IDN?
Reads out the model name and firmware version.
*LRN?
Reads out the setup state.
*OPT?
Reads out the installed option number.
*RST
Resets the instrument.
*SRE
Sets a mask (service request enable register) to the status byte register or
reads out it.
*STB? Reads out the contents of the status byte register.
*TRG
Triggers a measurement.
240
Function overview
[ T ]
[ V ]
[ X ]
[ * ]
4288A
:CORR:DATA on page 158
:CORR:SHOR on page 165
:CALC:COMP:SEC:LIM on page 145
:CORR:CKIT:STAN3:FORM on page 156
:CORR:LOAD on page 160
:CORR:DATA on page 158
*SAV on page 127
:CORR:CKIT:STAN3 on page 155
:TRIG:SOUR on page 196
N/A
:CORR:COLL on page 157
N/A
*CLS on page 124
*IDN? on page 125
N/A
*OPT? on page 126
:SYST:PRES on page 193
*SRE on page 127
*STB? on page 128
:TRIG on page 195
Appendix B