Routed., - Beckman Coulter LH 780 Instructions Manual

REPLACEMENT PROCEDURES
REPLACING REAGENT CONTAINERS
G Check the drawing you made in step 3. Make sure the tubing is properly routed.
H Press
I If necessary, prime the reagent associated with the tubing.
J Run a sample. Make sure that the new valve is correctly connected and there are no leaks.
3.11 REPLACING REAGENT CONTAINERS
WARNING Misleading results can occur if a diluent is used with the incorrect diff lytic reagent. Use only LH
Series Diluent with LYSE S
WARNING Some replaceable items can come in contact with residual biological material. Skin contact with
these materials can be harmful to your health. Dispose of these items in accordance with your laboratory
procedures.
Note: If you have Dual Diluent Pick-up Tubes installed, Beckman Coulter, Inc. (BCI)
recommends that you use diluent containers with the same lot number.
1. Remove any cardboard cutouts.
2. Remove the cap and seal from the new reagent container. Be sure to completely remove
the foil seal.
8. Tighten the cap.
9. Insert the plastic collar that secures the pickup tubes.
10. Record the new container¢s information in Quality Assurance Set Up.
11. Ensure the pneumatics are on.
3-24
START UP
®
III diff lytic reagent. Use only Isoton 4 Diluent with LYSE S
3. Remove the plastic collar that secures
the pickup tube assembly.
4. Unscrew the pickup tube assembly from
the old container.
5. Lift the assembly straight up and out.
IMPORTANT Incorrect results can occur if the
tubes become contaminated. Do not touch the
tubes or let them touch any laboratory surfaces. If
the tubes touch anything, rinse them with distilled
water and then wipe them with a lint-free tissue.
6. Inspect the pickup tube for damage, and
replace it if necessary.
7. Carefully insert the pickup tube
assembly straight into the new container.
®
4 diff lytic reagent.
PN 773023AC