Beckman Coulter LH 780 Instructions Manual page 242

INDEX
Sheath sample pressure below limit ‹<Tube ID>,
<Cass/Pos>›, 6-42
Sheath Tank Not Full,
Sheath Tank Still Full,
SPC A/D Status Error,
SPC Power Supply Bad,
SPC power supply defective,
SPC Status Not Ready,
Stack Overflow, 6-44
Stain Heater Disabled,
Stain heater disabled for current cycle,
Stain Heater Sensor Bad,
Stain Temp Hi. Heater Disabled,
Stain Temp Low. Run Stopped,
Stain temperature high, heater disabled,
Stain temperature low, heater disabled,
Stain temperature sensor failed,
Stripper Plate Not In,
Stripper Plate Not Out,
Stripper plate obstructed (not in) or faulty
sensor, 6-44
Stripper plate obstructed (not out) or faulty
sensor, 6-45
STX Rec. Error, 6-45
Sweep Flow Tank Not Full,
Sweep Flow Tank Still Full,
The C: drive is full. Please clear Print and
Transmission buffers from Run
Configuration, 6-65
The probe wipe harness is not connected,
Three Consecutive Voteouts,
Three consecutive voteouts of WBC, RBC, PLT or
MCV, 6-8
Two NAKs From Diluter,
Two NAKs Sent From AMC,
Unable to read cassette label,
Unknown Diff Error Message,
UNKNOWN Diluter Error Message,
Vacuum overflow tank full,
Vls Air Error, 6-47
Vls Diluent Error, 6-47
Waste container full, 6-32
Workload has been automatically reset in the
database, 6-66
Workload has been manually archived,
Workload has been manually printed,
Wrong Cal Factors, 6-48
Wrong Calibration Type, Sample will be stored as
a Patient Sample, 6-66
INDEX-12
6-43
6-43
6-43
6-43
6-43
6-43
6-44
6-44
6-44
6-44
6-44
6-44
6-44
6-44
6-44
6-45
6-45
6-45
6-38
6-8
6-46
6-46
6-29
6-47
6-47
6-31
6-66
6-66
Wrong Command Interpretation,
Wrong Command Sequence,
Wrong Echo Xmit, 6-48
Wrong Repro Type, latex Sample will not be
stored, 6-66
XB all batches were deleted,
XB current batch was deleted,
Workstation messages
about the message tables,
6-48
6-48
6-66
6-66
6-2
PN 773023AC