Beckman Coulter LH 780 Instructions Manual page 241

limit, 6-36
Power Supply 1 problem: -15 Volts above
limit, 6-36
Power Supply 1 problem: -15 Volts below
limit, 6-37
Power Supply 2 defective,
Power Supply 2 problem: +12 Volts above
limit, 6-37
Power Supply 2 problem: +12 Volts below
limit, 6-37
Power Supply 2 problem: +15 Volts above
limit, 6-37
Power Supply 2 problem: +15 Volts below
limit, 6-37
Power Supply 2 problem: +5 Volts above
limit, 6-37
Power Supply 2 problem: +5 Volts below
limit, 6-37
Power Supply 2 problem: -15 Volts above
limit, 6-38
Power Supply 2 problem: -15 Volts below
limit, 6-38
Precision test values within limits,
Probe Obstructed, 6-35
Probe Wipe Down Fail,
Probe Wipe Failed, 6-35
Probe Wipe Truck Not Home,
Probe Wipe Up Fail, 6-36
PS1 +15V Supply High,
PS1 +15V Supply Low,
PS1 +5V Supply High,
PS1 +5V Supply Low,
PS1 -15V Supply High,
PS1 -15V Supply Low,
PS2 +12V Supply High,
PS2 +12V Supply Low,
PS2 +15V Supply High,
PS2 +15V Supply Low,
PS2 +5V Supply High,
PS2 +5V Supply Low,
PS2 -15V Supply High,
PS2 -15V Supply Low,
R/W Data Mem. Interference,
Ramp Test values within limits,
Reagent <Reagent lot #> is expired,
Reagent level sense, pressure or voltage error
detected, 6-17
Red/white processor counter(s) did not
reinitialize, 6-39
Red/White Reset Error,
PN 773023AC
6-24
6-65
6-35
6-36
6-36
6-36
6-36
6-36
6-36
6-37
6-37
6-37
6-37
6-37
6-37
6-37
6-38
6-38
6-41
6-65
6-65
6-39
Replace reagent container,
Reservoir low on CBC lyse,
Reservoir low on cleaner,
Reservoir low on DIFF PAK,
Reservoir low on diluent,
Reservoir low on Retic PAK,
Retic Accumulation Not Finished,
Retic laser offset too low,
Retic Laser Offset Upper Failed,
Retic Pressure Lower Failed,
Retic Pressure Upper Failed,
Retic sample pressure above limit (<Tube ID>,
<Cass/Pos>), 6-39
Retic sample pressure below limit (<Tube ID>,
<Cass/Pos>), 6-39
Retic Xmit Failure, 6-39
RF (6.3V) voltage reading above limit (<Tube ID>,
<Cass/Pos>), 6-40
RF (6.3V) voltage reading below limit (<Tube ID>,
<Cass/Pos>), 6-40
RF Lower Limit Failed, 6-40
RF Upper Limit Failed, 6-40
RF Voltage Low, 6-40
RF voltage reading below limit,
Right Lift Not Down, 6-40
Right Lift Not Up, 6-40
Right Stack Full, 6-40
Rocker bed did not advance,
Rocker bed obstructed (left lift not down) or faulty
sensor (<Tube ID>, <Cass/Pos>),
Rocker bed obstructed (left lift not up) or faulty
sensor (<Tube ID>, <Cass/Pos>),
Rocker bed obstructed (right lift not down) or
faulty sensor (<Tube ID>, <Cass/Pos>),
Rocker bed obstructed (right lift not up) or faulty
sensor (<Tube ID>, <Cass/Pos>),
Run Aborted. PC Not Ready,
Same Label Read Run Stopped,
Sample ID portion of the Positive ID has
changed, 6-65
Sample Removed Too Soon,
Sample Tube Not Detected,
Scanner Error, 6-42
Scanning Fault, 6-42
Sensor detected diluted blood or non-blood sample
(<Tube ID>, <Cass/Pos>),
Sheath Pressure Lower Failed,
Sheath Pressure Upper Failed,
Sheath sample pressure above limit (<Tube ID>,
<Cass/Pos>), 6-42
INDEX
6-31
6-31
6-30
6-31
6-31
6-31
6-39
6-39
6-39
6-39
6-39
6-40
6-13
6-30
6-30
6-40
6-40
6-41
6-42
6-42
6-42
6-11
6-42
6-42
INDEX-11