Completing The Installation; Checking Image Quality - Konica Minolta DRYPRO SIGMA Service Manual

Completing the Installation

Checking Image Quality

Laser Imager
Back Cover
[1] Connect the network cable to the:
• Network connector on the laser imager.
• Nearest active building network connector.
[2] After the laser imager has completed the warm-up cycle, send an image from each modality that will print to
the laser imager.
Note
The default port No. of the laser imager is set to 5040.
[3] If the image quality must be improved for a modality, optimize the images from that modality:
(a) From the main screen, select Wizards > Image Quality.
(b) Cancel all pending print jobs or wait until all print jobs are printed.
(c) Under Optimization Steps, click
(d) Send an image from the modality, and then click
Note
The image does not print until you click the button.
(e) View the test print and visually select the optimal image.
(f) Under Image Number, click
(g) Under Optimization Steps, click
(h) Check the status and result data near the bottom of the screen.
(i) Send another image from the modality and check the print.
Note
If none of the images are optimal for the site, see Additional Service Procedures,
[4] Continue with
"Backing Up the System
A4A9YG220B_111019
Network Connector
.
to select the number of your optimal image.
again to continue.
Configuration".
.
"Checking Image
Installation Instructions
Quality".
1-13