Konica Minolta DRYPRO SIGMA Service Manual page 139

Condition Code: 26-326 – Jam Exiting Exposure Transport to Processor
Web Portal Message
Film Jam in Area 2 or 3 Film Jam Exiting
Description
System Impact
User Action
Show at DS
DICOM Printer
Status
Unique Symb. ID
Logged for RMS
9G9002 – 2011-08-15
Log Message
Exposure Transport to
Processor: SOP sensor
(S6) failed to detect film
trailing edge
This error occurs if the trailing edge (as determined by film direction) is not
detected at the SOP (start-of-page) sensor (S6) after the film has entered the
exposure transport area from the accumulator on its way to the processor. The
error is cleared when the film supply is opened then closed.
When this error occurs, the processor stops rotating and the heater is turned
off. All jobs in the imager will fail and then automatically reprint.
The imager can only print jobs that were in process when the error occurred.
The spooler can still accept jobs, but the jobs will not print until the error is
resolved. All jobs that were in process when the error occurred will reprint
completely when the error is resolved. [SI-1]
Clear the jam (see "Film Jam in Area 2 or 3 – Error Code 326 (Web Portal code
26326)").
True
WARNING
ERR_PRE_DENSITOMETER_JAM
[CartridgeInfo=bbeeee-cjj-d-iii][FilmSize=size]
DICOM Printer
StatusInfo
FILM JAM
Diagnostics
Severity
1-Alert
4-61