Table of Contents
Advertisement
Connecting to Electrical Power
[1] Locate the power cord. The power cord must match the AC power outlets at your site.
If you cannot use the power cord that is provided, obtain a suitable power cord locally. You must use an agency-
approved power cord rated for adequate amperage with a plug type suitable for your location. Contact your
dealer if you need assistance.
[2] Check that the voltage on the label over the power cord inlet matches the AC voltage at your site.
Caution
If the voltage on the label does not match the AC voltage at your site, do not continue with the installation.
Power cord inlet labels and connectors
Laser Imager
Back Cover
H221_6001AC
[3] Remove the power cord inlet label.
Caution
Caution
Risk of electric shock: Dangerous voltage!
[4] Connect the power cord to the:
• AC power connector on the laser imager.
• Building AC power outlet.
9G9002 – 2011-08-15
or
or
100 - 120 V
200 - 240 V
Installation Instructions
1-7
Hide quick links:
Advertisement
Table of Contents
