Configuring The Laser Imager - Konica Minolta DRYPRO SIGMA Service Manual

Configuring the Laser Imager

This section instructs how to configure the laser imager using the same methods available to the customer in the
Installation Manual, 9G7567. For additional and more comprehensive configuration procedures, see
Additional Service Procedures.
Important
You must restart the laser imager from the service tool to permanently save configuration information.
Setting Up Your Computer to Communicate with the Laser Imager
Do this procedure at your computer.
[1] Select Start > Settings > Network Connections.
Note
Depending on your operating system, this might be Start > Settings > Network and Dial-up Connections.
[2] Right-click Local Area Connection.
[3] Select Properties.
[4] Select Internet Protocol (TCP/IP).
[5] Click Properties.
Important
Remember or write down your current settings, as you will reset your computer to these settings near the end of the
installation.
[6] Select the Obtain an IP address automatically option.
[7] Click OK.
[8] Click OK.
9G9002 – 2011-08-15
Installation Instructions
Section 6:
1-9