Additional Service Procedures; Accessing The Service Tool - Konica Minolta DRYPRO SIGMA Service Manual

Section 6: Additional Service Procedures

Accessing the Service Tool

Logging On to the Service Tool
Important
• You must have the Secure Link Client Software, version 2.3 or higher and the Web Service Portal Software,
version 3.1.0.5 or higher installed and configured on your laptop computer.
• You will not be able to log on until 3 or 4 minutes after you have energized the laser imager.
[1] Connect the laptop computer to the laser imager (see Installation Instructions,
the Laser Imager").
[2] Energize the laptop computer.
[3] Launch Secure Link from the Start menu.
[4] Type your password.
[5] Click OK.
[6] Type the IP address of the Service Port: 192.168.000.1.
[7] Check that the Port is set to 443.
[8] Click Connect.
[9] Launch the Web Service Portal Software (Web Portal) from the Start menu.
The main menu of the service tool displays.
Logging Off the Service Tool
[1] In the right corner of the service tool, click Log Off.
[2] At the Web Portal screen, click Log Off.
[3] Close the Web Portal software.
[4] At the Secure Link screen:
(a) Click Disconnect.
(b) Close the screen.
[5] Disconnect the laptop computer from the laser imager.
[6] If you are finished with the service tool, install the right cover.
9G9002 – 2011-08-15

Additional Service Procedures

"Connecting Your Computer to
6-1