Machine Control System (Mcs) Board - Konica Minolta DRYPRO SIGMA Service Manual

SERVICE MANUAL

Machine Control System (MCS) Board

Prerequisites:
T10 Torx driver
Tools:
Removal
ESD
Possible damage from electrostatic discharge.
When installing circuit boards, always use a wrist strap to prevent damage from electrostatic
discharge.
Screws
Connectors
[1] Disconnect all connectors.
[2] Remove:
• 6 screws
• Machine Control System (MCS) board
Installation
Reverse the steps in the removal procedure.
Note
If necessary, perform "Restoring the
2-44
• Perform "Making a Configuration
• Close the film cartridge. (Touch the Pause button on the display screen.)
• De-energize the laser imager.
• Disconnect the power cord.
• Remove the:
– Top cover
– Right cover
Configuration".
Backup".
9G9002 – 2011-08-15