Table of Contents
Advertisement
SERVICE MANUAL
Modifications
Important
Check the modification status of the imager at each PM call. If any Type 1 modifications are outstanding, install them
during the call. It is important to fit modifications promptly at scheduled maintenance times to improve and maintain
imager performance to corporate and customer expectations.
EM Call Checklist
If the number of prints since the last PM is more than 18,500, use the 20,000 Cycle PM Procedure instead of the EM
call checklist.
[1] Repair the print problem that caused the EM call.
[2] Touch the Pause icon on the display screen to close the film cartridge.
[3] De-energize the laser imager, and then disconnect the power cord.
[4] Remove the:
• Top cover
• Left cover (see Adjustments and Replacements,
• Right cover (see Adjustments and Replacements,
Caution
The processor drum is very hot.
[5] Remove the 2 rear screws on the
imager.
Rear Screw
[6] Check the processor drum for damage.
If the processor drum is damaged, replace it (see Adjustments and Replacements,
3-2
processor drum
Left Side of Imager
"Left
cover").
"Right
Cover").
cover, and then pivot the cover open toward the front of the
Right Side of Imager
Rear Screw
"Processor
Drum").
9G9002 – 2011-08-15
Hide quick links:
Advertisement
Table of Contents
