Performing The Pm - Konica Minolta DRYPRO SIGMA Service Manual

SERVICE MANUAL

Performing the PM

Every PM, perform all of the following procedures in the order listed:
[1] Print a flat-field gray film to compare against the film after PM is complete.
(a) In the service tool, select Diagnostics > DRE > Advanced Test Print.
(b) In the Test Profile drop-down list, select Flat1.8.
(c) Click Run.
[2] Touch the Pause icon on the display screen to close the film cartridge.
[3] Open the film supply and remove the film cartridge. Leave the film supply open.
[4] De-energize the imager, and then disconnect the power cord.
[5] Remove the:
• Top cover (see Adjustments and Replacements,
• Left cover (see Adjustments and Replacements,
• Right cover (see Adjustments and Replacements,
Caution
The processor drum is very hot. Allow it to cool for 10 minutes before cleaning.
Pivot open the processor drum
[6]
Continue with the next steps while the processor drum cools.
[7] Remove the deodorant filter.
[8] Use a vacuum cleaner to clean the:
• Deodorant filter area
• Filter duct
• Exhaust plenum
3-4
"Top
"Left
"Right
cover.
Cover").
cover").
Cover").
9G9002 – 2011-08-15