Konica Minolta DRYPRO SIGMA Service Manual page 129

Condition Code: 21-125 – Feed Roller Nip Failure
Web Portal Message
Film Supply: Internal
Hardware Failure
Description
System Impact
User Action
FE Action
FE Action
(continued)
Show at DS
DICOM Printer
Status
Unique Symb. ID
9G9002 – 2011-08-15
Log Message
Film Supply: Feed
Roller Sensor (S5)
failed to detect feed
roller open/closed
position.
This error occurs if the feed roller nip sensor (S5) does not change from
unblocked to blocked when opening or from blocked to unblocked when
closing. The most likely cause is the motor (M1) did not turn or the sensor did
not detect the motion.
The error is cleared when a film cartridge is removed and then re-inserted.
Cannot print from the loaded film cartridge. The spooler is still able to accept
and queue jobs. [SI-2]
1. Close the film cartridge.
2. Remove the film cartridge from the laser imager.
3. Re-insert the cartridge.
4. If the error persists, call for service.
Perform the actions below in sequence. If an action provides a resolution, do
not continue with the other actions.
1. De-energize then energize the laser imager.
2. Do the following:
Check:
all connectors and cables
the feed roller NIP sensor
the feed roller NIP open/close
motor
3. Install a new pickup assembly (see Adjustments and Replacements,
Assembly").
True
WARNING
ERR_UP_FEED_ROLLER
DICOM Printer
StatusInfo
FILM TRANS ERR
If an existing problem:
Seat all connectors.
Install a new sensor.
Install a new motor (see Adjustments and
Replacements, "Feed Roller
Diagnostics
Severity
1-Alert
Motor").
"Pickup
4-51