Konica Minolta DRYPRO SIGMA Service Manual page 9

[5] To move the front shipping bracket:
(a) Open the film supply.
(b) Remove 4 screws that fasten the shipping bracket.
Front view of laser imager
[6] Use 2 of the screws to reattach the shipping bracket in the alternate set of holes on the left side of the rail.
Front
Shipping Bracket Shipping
reattached
Bracket in
Storage
[7] Retain the other 2 bracket screws: Install the screws into any of the empty holes where the bracket was attached
earlier.
9G9002 – 2011-08-15
Front Shipping
Bracket
Shipping Bracket
( lter removed)
Installation Instructions
1-5