Installation Of The Ccd Unit; Removal Of The Scanner, Exposure Lamp, And Inverter Board (Pu2) - Konica Minolta Di1611 Service Manual

MAINTENANCE
(2)

Installation of the CCD Unit

(3)

Removal of the Scanner, Exposure Lamp, and Inverter Board (PU2)

1. Remove the Original Glass and Original Scanning Glass.
☞ 1-25
2. Remove two screws (to which no red paint has been applied). Then, remove the Scan-
ner Assy from the Scanner Drive Cables.
NOTE
• Removal of the Scanner Assy leaves the front and rear Scanner Drive Cables attached
with the fixing brackets.
1. Position the CCD Unit along the marking line.
Then, temporarily secure three screws at the
center of each of the screw slots.
2. Adjust the position of the CCD Unit.
☞ 2-57
4035D077AA
3. Remove one screw and the cable holder.
4035D079AA
1-40
Di1611/Di2011 FIELD SERVICE Ver.1.0 Mar. 2004
4035D078AC