Memory Channel Programming - Icom ID-51A Advanced Instructions

Previous view
12

MEMORY CHANNEL PROGRAMMING

■ Memory channel programming
Push [V/MHz] to select the VFO mode.
q
Set a desired frequency and operating mode:
w
Rotate [DIAL] to set a desired frequency.
➥
(Example: 146.030)
Push [MODE]
➥
desired operating mode. (Example: FM mode)
Set the duplex direction, frequency offset, tone
➥
squelch, and so on, if needed.
Hold down [S.MW]
e
lect Memory write mode.
• 1 short and 1 long beep sound.
• The memory channel number blinks, and memory con-
tents are displayed.
Rotate [DIAL] to select a desired channel to be pro-
r
grammed.
(Example: Channel 11)
Hold down [S.MW]
t
then return to the VFO mode.
• 3 beeps sound.
• Before returning to the VFO mode, the programmed
memory contents are briefly displayed.
• The Memory channel number automatically increases
when continuing to hold down [S.MW]
after programming.
NOTE: Push [CLR]
exit the Select Memory write mode before memory
programming.
one or more times to select a
for 1 second to enter the Se-
for 1 second to program, and
for 1 second
to cancel the program and
[DIAL]
Example: Programming 146.030 MHz/FM mode into
memory channel 11 (a blank channel).
12-4
Set 146.030MHz in
the VFO mode.
Hold down [S.MW]
for 1 second to enter
the Select Memory write
mode.
Rotate [DIAL] to select a
channel 11.
Hold down [S.MW]
for 1 second to program.
Returns to the VFO mode.