Icom ID-51A Advanced Instructions page 117

Previous view
9
D-STAR OPERATION <ADVANCED>
Repeater list programming (Continued)
■
11. Position data accuracy level setting
When the Repeater Search function is not used, or
the distance between your position and a repeater is
not displayed, select "OFF."
$4 Push D-pad( ) to select "POSITION," and then push

D-pad(Ent).
D-pad
(Ent)
(�)
$5 Push D-pad( ) to select the position data accuracy

level.
• None : Select when the repeater has no position
data.
• Approximate: Select when the programmed position data
is approximate.
• Exact : Select when the programmed position data
is exactly correct.
$6 After setting, push D-pad(Ent).
12. Latitude programming
This item appears only when "Approximate" or "Ex-
act" is selected in [11. Position data accuracy level
setting].
$7 Push D-pad( ) to select "LATITUDE," and then push

D-pad(Ent) to enter the latitude data edit mode.
• A cursor appears and blinks.
$8 Rotate [DIAL] to input the latitude.
$9 Push to move the cursor backward, or push
move the cursor forward.
%0 Repeat steps $8 and $9 to enter the latitude.
%1 After entering, push D-pad(Ent).
13. Longitude programming
This item appears only when "Approximate" or "Ex-
act" is selected in [11. Position data accuracy level
setting].
%2 Push D-pad( ) to select "LONGITUDE," and then

push D-pad(Ent) to enter the longitude data edit
mode.
• A cursor appears and blinks.
%3 Rotate [DIAL] to input the longitude.
%4 Push to move the cursor backward, or push
move the cursor forward.
%5 Repeat steps %3 and %4 to enter the longitude.
%6 After entering, push D-pad(Ent).
to
to
9-30
☞ Continued on the next page.