Copying Memory And Call Channel Contents; D Memory Or Call Channel Vfo - Icom ID-51A Advanced Instructions

Previous view
12
MEMORY CHANNEL PROGRAMMING

■ Copying memory and Call channel contents

This function copies a memory channel's contents to
the VFO, another memory or Call channels. This is use-
ful when searching for signals around a memory chan-
nel frequency, and for recalling the frequency offset,
subaudible tone frequency and so on.
D Memory or Call channel
Select the Memory or Call channel to be copied.
q
Push [M/CALL]
➥
the Memory mode or the Call channel mode, then
rotate [DIAL] to select a desired channel.
Hold down [S.MW]
w
Select Memory write mode, and copy the memory
contents.
• 1 short and 1 long beep sounds.
• The memory channel number blinks.
Rotate [DIAL] to select "VFO."
e
Hold down [S.MW]
r
lected channel contents to the VFO.
• The transceiver automatically returns to the VFO.
NOTE: Holding down [S.MW]
step w will also copy the memory contents to the
VFO. In that case, steps e and r are not neces-
sary.
VFO
one or more times to select
for 1 second to enter the
for 1 second to copy the se-
for 2 seconds in
[DIAL]
12-5
Select the memory or call
channel to be copied.
Hold down [S.MW]
for 1 second to enter
the Select Memory write
mode, and then, rotate
[DIAL] to select "VFO."
Hold down [S.MW]
for 1 second to copy.
The selected channel
contents appear in the
VFO screen.